270
E Jackson Street (US RT 6)
Seneca,
IL 61360
815/357-3292,
FAX 815/357-9920
Trailer Parts,
Service, Sales and Rentals
2012 Ford F-350 Super-Duty Truck
Aftermarket Trailer Brake Controller Install
Wire colors to the controller
(Tekonsha and some others):
Black, Battery Positive to controller
White, Negative Ground for Controller
Blue, Brake feed from controller to
Trailer plug at back of truck
Red, tap into truck Brake light switch
signal to tell controller to apply brakes
Remember, the above colors are just a
GUIDE. your colors may be different, read the
instructions!
This Super Duty was not equipped with
the Ford Factory installed Brake controller. It is VERY
EASY to install a Hi Performance Aftermarket Trailer
controller in these trucks, even though Ford may indicate
otherwise. Just click here to get the controller and
Harness you need, and in
less than 10 minutes you are done!
The Harness is PLUGGED in the back of
the Change Pocket. (I suppose just to keep it from
Bouncing around) so you need to pop out the Cigar Lighter
with a small screwdriver in the slot on the bottom of the
bezel (see pictures), reach through and un-hook the
Controller plug from the back of the Change holder. Then
simply plug in the Ford Super duty Harness and mount the
controller!
Done!
Below- Close up of the tabs that hold
the Cigar lighter bezel in (just slip tabs) and the Brake
controller plug. (click to see a high detail picture)