2009 Kia Sedona Trailer
Brake Controller Install
Please visit my general install page
for overall instructions
I
sell brake controllers, so please, if you need one
click here! We keep Prodigy P2 Brake Controllers in
Stock Regularly!
"Standard" Wire colors to the
controller (Tekonsha and others):
- Black, Battery Positive to controller
- White, Negative Ground for Controller
- Blue, Brake feed from controller to Trailer plug at
back of truck
- Red, tap into truck Brake light switch signal to
tell controller to apply brakes
Remember, the above colors are just a GUIDE.
your colors may be different, read the instructions!
Click on Any
Picture for A Larger, Higher Quality Image |
|
|
Brake light
switch close up. Squeeze top of plug to pull out
connector to make it easier to reach wires.
|
We tapped into the
WHITE wire for the brake light signal (red wire on the
controller) Test to be sure, it must power on when the
brake pedal is pushed.
Battery feed was taken from the main fuse panel (under
the hood)
The Ground wire (white) was grounded under the dash
(see screw in picture)
We used a 15 amp circuit breaker under the hood to
power a battery feed both to the brake controller, and
the 12 volt power to the plug at the back
Click on Any
Picture for A Larger, Higher Quality Image |
|
|
|
We used a common
tail light kit, then wired it to a standard 7 way plug
Click on Any
Picture for A Larger, Higher Quality Image |
|
|
|