 |
 |
 |
 |
 |
 |
|
2004-2014 Nissan Titan
Brake Controller Installation
Please visit my general install page
for overall instructions - Black, Battery Positive to controller - White, Negative Ground for Controller - Blue, Brake feed from controller to Trailer plug at back of truck - Red, tap into truck Brake light switch signal to tell controller to apply brakes Remember, the above colors are just a GUIDE. your colors may be different, read the instructions! Click Here to see the installation instructions from Tekonsha Below is a example in a 2005 Titan, other may be
similar: Installing a brake control unit isn't very difficult. This task is made even easier if your tow vehicle is a late model and comes with a 7 Way Connector as part of the towing package. Nissan Titans with the "Big Tow" Package will have the wire connectors in place. In this case, installation is as simple as mounting the
brake controller in a convenient, easy to reach place,
usually under the dash, just above your right leg and
connecting the wires from the brake control to the
wiring harness and then plugging the harness into the
harness located under the dash. On Nissan Titan trucks, with the tow package, the factory provided a plug under the dash to connect the brake controller. On the trucks I have done, it is a plug, located up in the dash, just above park brake, up under the dash. You must have the factory plug harness to plug in (I sell these, if you need one, hint, hint) The connector is taped to a wire harness to the left of the steering column. The easy way to get to it is to remove the plastic trim below the steering column. There are two phillip head screws at the bottom. Remove those and the panel will then snap off. You can then get to the connector.
|
||||||
